![]() ![]() If power and volume buttons work correctly on the remote then proceed to step #4. Test the remote to make sure that you have the correct code by doing the following: Press Power ON/OFF and VOLUME + /. Once your TV shuts off, immediately remove your finger from the Setup button the code automatically locks in. The LED will continue to blink every 2 seconds. The LED will blink once and then after 7 seconds it will initiate code search. It will not be necessary to point the remote at that exact area once the remote is set-up. Point the remote at the CENTER of the front panel of the TV. Manually turn on the TV and the Cable Box and then If you do not have an individual cable box in each guest room, scroll down to TV ONLY INSTRUCTIONS ![]() If the LED doesn't light, then the batteries are either in wrong or the batteries are bad.įOR TV WITH AN INDIVIDUAL CABLE BOX IN EACH GUEST ROOM, START HERE: Test remote by pressing the power button the LED should light indicating that the batteries are in correctly. When placing AAA batteries in the compartment note the + and - symbols on the metal hinge should make contact with the corresponding + and - end of each battery (photo B).Ĭlosing cover: With keypad facing away from you gently close cover by pressing downward (photo C, step 1) and sliding it toward the front (keypad) until it is aligned. Open cover: With keypad facing you, first slide dark lens cover away from you (photo A, step 1) and then lift lid upward from the back (photo A, step 2) Will not operate with LodgeNet® or OnCommand® movie systems Will not operate TV/DVD, VCR or DVD/VCR combination units. Hidden Battery compartment and attached door to help prevent batteries from being takenĬompatible with Comcast® and other cable system boxes No Menu button - So Patients and Guests cannot change settings Works over 250 brands of commercial and retail TVs INSTRUCTIONS FOR CR1R CLEAN REMOTE® (Remote for TV with CABLE BOX) ![]()
0 Comments
Leave a Reply. |